(Do you have Jetson’s Strike Hoverboard ? Take note: When this hoverboard is turned vertically onto its wheel, the battery indicator light will also serve to notify you which speed mode the hoverboard is set in. One green light or one flashing green light - Your battery has a charge under 20%.Two green lights – The battery has a charge between 21% and 49%.Three green lights – Your hoverboard’s battery has a charge at or above 50%.Hoverboards with three adjacent battery indicator lights also communicate the level of charge: Red or flashing red - Your battery has a charge under 20%.Yellow - The battery has a charge between 21% and 49%.Green - Your hoverboard’s battery has a charge at or above 50%.If your hoverboard has a single indicator light, it will illuminate in one of three colors. Understanding what and how they communicate can make for a much better riding experience.ĭepending on the model, your Jetson Hoverboard will have either a single battery indicator light or a set of three. They’re located on the top of the board in between the foot pads. Go get you some tools with the money you save by fixing your own car.Your Jetson hoverboard has two types of indicator lights: one to convey its battery charge and another to tell you the status of your board’s internal balance mechanisms. Their hand tools are pretty good, are better than auto parts store tools and have a lifetime warranty. If you need tools go to Google Maps and type 'Harbor Freight', then go there. Alternators are relatively easy to change. You can easily fix any issue with your car with the wealth of knowledge available on the net and YouTube. No need to go to an 'auto-electrician', again this is overkill and worse case. These can both be done with the parts still on your car in the parking lot. If all the basics pass the test, then go to any major auto parts chain and have them run a load test on your battery in addition to a charging test on the alternator. Touch the tops with your finger and try to wiggle. If everything is clean and tight you should move on to the fuse box.Only touch the bolt you are tightening on the Positive side. Take care when using metal tools on the Positive cable, you can ground the battery out or worse. Start at the top near the battery and follow cables to other end. Then follow the cables to their respective opposite ends. Try to move the cables at the battery, they should be firmly attached.

If cables and battery are clean, then you should make sure everything is tight.They sell $2 battery terminal cleaners at ever auto parts store as well. If the cables have white dust on them, then the ends of the cables and the battery post need to be cleaned. A visual check of your positive and negative battery cable should be first after the above, best part is it's free! You are looking for corrosion where the cable meets the battery (White dust on cable at the battery).If it is more than 3 years old, have it tested. Check if there is a date sticker on the top of your battery.These are more than often the culprits anyways, so best to save time and money. When troubleshooting you should always start with the easiest and/or cheapest solution. A bad alternator or battery is by far worse case scenario.

Flashing battery light